:: and .
There are a few subtle differences between the Modula-2 scope operator
(.) and the scope operator (::). The two have
similar syntax:
module . id scope :: id
where scope is the name of a module or a procedure, module the name of a module, and id is any declared identifier within your program, except another module.
Using the :: operator makes search the scope
specified by scope for the identifier id. If it is not
found in the specified scope, then searches all scopes
enclosing the one specified by scope.
Using the . operator makes search the current scope for
the identifier specified by id that was imported from the
definition module specified by module. With this operator, it is
an error if the identifier id was not imported from definition
module module, or if id is not an identifier in
module.
Go to the first, previous, next, last section, table of contents.