Starting your program

run

r

Use the run command to start your program under . You must first specify the program name (except on VxWorks) with an argument to (see section Getting In and Out of), or by using the file or exec-file command (see section Commands to specify files).

If you are running your program in an execution environment that supports processes, run creates an inferior process and makes that process run your program. (In environments without processes, run jumps to the start of your program.)

The execution of a program is affected by certain information it receives from its superior. provides ways to specify this information, which you must do before starting your program. (You can change it after starting your program, but such changes only affect your program the next time you start it.) This information may be divided into four categories:

The arguments.

Specify the arguments to give your program as the arguments of the run command. If a shell is available on your target, the shell is used to pass the arguments, so that you may use normal conventions (such as wildcard expansion or variable substitution) in describing the arguments. In Unix systems, you can control which shell is used with the SHELL environment variable. See section Your program's arguments.

The environment.

Your program normally inherits its environment from , but you can use the commands set environment and unset environment to change parts of the environment that affect your program. See section Your program's environment.

The working directory.

Your program inherits its working directory from . You can set the working directory with the cd command in . See section Your program's working directory.

The standard input and output.

Your program normally uses the same device for standard input and standard output as is using. You can redirect input and output in the run command line, or you can use the tty command to set a different device for your program. See section Your program's input and output. Warning: While input and output redirection work, you cannot use pipes to pass the output of the program you are debugging to another program; if you attempt this, is likely to wind up debugging the wrong program.

When you issue the run command, your program begins to execute immediately. See section Stopping and Continuing, for discussion of how to arrange for your program to stop. Once your program has stopped, you may call functions in your program, using the print or call commands. See section Examining Data.

If the modification time of your symbol file has changed since the last time read its symbols, discards its symbol table, and reads it again. When it does this, tries to retain your current breakpoints.

Go to the first, previous, next, last section, table of contents.