attach process-id
info files shows your active
targets.) The command takes as argument a process ID. The usual way to
find out the process-id of a Unix process is with the ps utility,
or with the `jobs -l' shell command.
attach does not repeat if you press RET a second time after
executing the command.
To use attach, your program must be running in an environment
which supports processes; for example, attach does not work for
programs on bare-board targets that lack an operating system. You must
also have permission to send the process a signal.
When you use attach, the debugger finds the program running in
the process first by looking in the current working directory, then (if
the program is not found) by using the source file search path
(see section Specifying source directories). You can also use
the file command to load the program. See section Commands to specify files.
The first thing does after arranging to debug the specified
process is to stop it. You can examine and modify an attached process
with all the commands that are ordinarily available when
you start processes with run. You can insert breakpoints; you
can step and continue; you can modify storage. If you would rather the
process continue running, you may use the continue command after
attaching to the process.
detach
detach command to release it from control. Detaching
the process continues its execution. After the detach command,
that process and become completely independent once more, and you
are ready to attach another process or start one with run.
detach does not repeat if you press RET again after
executing the command.
If you exit or use the run command while you have an
attached process, you kill that process. By default, asks
for confirmation if you try to do either of these things; you can
control whether or not you need to confirm by using the set
confirm command (see section Optional warnings and messages).
Go to the first, previous, next, last section, table of contents.