A breakpoint makes your program stop whenever a certain point in
the program is reached. For each breakpoint, you can add conditions to
control in finer detail whether your program stops. You can set
breakpoints with the break command and its variants (see section Setting breakpoints), to specify the place where your program
should stop by line number, function name or exact address in the
program.
In HP-UX, SunOS 4.x, SVR4, and Alpha OSF/1 configurations, you can set
breakpoints in shared libraries before the executable is run. There is
a minor limitation on HP-UX systems: you must wait until the executable
is run in order to set breakpoints in shared library routines that are
not called directly by the program (for example, routines that are
arguments in a pthread_create call).
A watchpoint is a special breakpoint that stops your program when the value of an expression changes. You must use a different command to set watchpoints (see section Setting watchpoints), but aside from that, you can manage a watchpoint like any other breakpoint: you enable, disable, and delete both breakpoints and watchpoints using the same commands.
You can arrange to have values from your program displayed automatically whenever stops at a breakpoint. See section Automatic display.
A catchpoint is another special breakpoint that stops your program
when a certain kind of event occurs, such as the throwing of a C++
exception or the loading of a library. As with watchpoints, you use a
different command to set a catchpoint (see section Setting catchpoints), but aside from that, you can manage a catchpoint like any
other breakpoint. (To stop when your program receives a signal, use the
handle command; see section Signals.)
assigns a number to each breakpoint, watchpoint, or catchpoint when you create it; these numbers are successive integers starting with one. In many of the commands for controlling various features of breakpoints you use the breakpoint number to say which breakpoint you want to change. Each breakpoint may be enabled or disabled; if disabled, it has no effect on your program until you enable it again.
Some commands accept a range of breakpoints on which to operate. A breakpoint range is either a single breakpoint number, like `5', or two such numbers, in increasing order, separated by a hyphen, like `5-7'. When a breakpoint range is given to a command, all breakpoint in that range are operated on.
Go to the first, previous, next, last section, table of contents.