Installing Info Directory Files

When you install an Info file onto your system, you can use the program install-info to update the Info directory file dir. Normally the makefile for the package runs install-info, just after copying the Info file into its proper installed location.

In order for the Info file to work with install-info, you include the commands @dircategory and @direntry...@end direntry in the Texinfo source file. Use @direntry to specify the menu entries to add to the Info directory file, and use @dircategory to specify which part of the Info directory to put it in. Here is how these commands are used in this manual:

     @dircategory Texinfo documentation system
     @direntry
     * Texinfo: (texinfo).           The GNU documentation format.
     * install-info: (texinfo)Invoking install-info. ...
     ...
     @end direntry
     

Here's what this produces in the Info file:

     INFO-DIR-SECTION Texinfo documentation system
     START-INFO-DIR-ENTRY
     * Texinfo: (texinfo).           The GNU documentation format.
     * install-info: (texinfo)Invoking install-info. ...
     ...
     END-INFO-DIR-ENTRY
     

The install-info program sees these lines in the Info file, and that is how it knows what to do.

Always use the @direntry and @dircategory commands near the beginning of the Texinfo input, before the first @node command. If you use them later on in the input, install-info will not notice them.

If you use @dircategory more than once in the Texinfo source, each usage specifies the `current' category; any subsequent @direntry commands will add to that category.

When choosing the categories for @dircategory, we recommend consulting the http://www.gnu.org/directory. If your program is not listed there, or listed incorrectly or incompletely, please report the situation to the directory maintainers ([email protected]) so that the category names can be kept in sync.

Here are a few examples:

     Emacs
     Localization
     Printing
     Software Libraries
     

Each `Invoking' node for every program installed should have a corresponding @direntry. This lets users easily find the documentation for the different programs they can run, as with the traditional man system.